How to make a better than basic Kill tunnel / entrance.

[its cgilb569]

 

 

Things that need to be mentioned

1. this entrance counts as an 180 turn.

2. you must be able to run to the top of the ramp and land on the platform behind it without jumping.

3. This works in most base spots if they aren't too tight.

4. be careful with the ramp make sure u can run both up and down at base speed.

Steps.

Step I. Pick your location ( this is the one I used )

 

Step II. make a three unit wide kill tunnel to your desired length any 90 degree turns made will have to be doubled so dont have more than 1.

Step III. At the end of your kill tunnel move back the roof about 4 units can be a little less.

Step IV. get a ramp( the teeth) from the gear section and place it at a slight angle.

Step V.  stacker all of your walls up 1.

Step VI. add a back to the walls if you haven't already.

Step VII. Add a roof to the second floor.

Step VIII. double stack each wall out of the kill tunnel.

Step IX. Get the transparent material. ( the one shown in the first photo)

Step X. add it to the inner layer of walls.

Step XI. get glow version of your color on the walls inside the kill tunnel. 

Step XII. add your glow color to the walls in the kill tunnel.

Step XIII. patch up any holes and add a way into the top of the tunnel from the inside.

Step XIV. add your 3 Fading doors and crack ramps if wanted.

Step XV. (this step isn't necessary but makes your base look nicer) go into color and put the transparent as close to zero as u can ( 1 is the best ). Then color the transparent walls that color, make sure it's normal, not any type of glow.

It should look like this except with all of the doors added in.

 

 

[Perk]

k

[Maze]

Aka how to make Maze Base pls change title

[BEAN B0Y]

brotha buildin outta plastic???

[its cgilb569]

22 hours ago, BEAN B0Y said:

brotha buildin outta plastic???

yea ill make an updated one but need to relearn the metas

 

[Trosa]

Moved

Thanks for this it should be a lot of help